Free quote
FAQ

Pool Tile Cleaning Questions

Common questions about pool tile cleaning, bead blasting and calcium removal.

  • No draining with soda media
  • Done in hours, not days
  • Homes, rentals & HOAs

Get a free tile cleaning quote

Tampa to Naples. No obligation.

Questions

How much does pool tile cleaning cost?

Local pros typically start at about $10–12 per linear foot of tile. A common home pool has roughly 80–120 feet of tile line, so many jobs land around $800–$1,450, more with a spa or heavy scale. Use the cost calculator for a ballpark.

Do you drain the pool?

No. The water is usually lowered just below the tile line, the tile is cleaned, then the pool is refilled and the water balanced.

Will bead blasting damage my tile or grout?

Wet blasting with soda media knocks off calcium without harming glazed or glass tile. Heavier glass bead is saved for very thick scale. The pro checks your tile and can test a small area first.

How long does it take?

Most residential tile lines take a few hours of blasting, plus time to lower and refill the water.

What causes the white line on pool tile?

Calcium in Florida water comes out of solution as water evaporates, especially when pH runs high or with salt systems. Over time it hardens into scale.

What media is used?

Soda blast media (sodium bicarbonate) for most pools that stay filled, because it dissolves in the water. Glass bead for very thick scale, mainly on pools that are drained, because glass does not dissolve and has to be cleaned up.

Does soda media affect my water?

Dissolved baking soda raises alkalinity and pH a little, so the water is tested and balanced after the job. Your pool service can handle it, or ask the pro.

How can I tell carbonate from silicate scale?

Calcium carbonate is usually white and flaky and may fizz with a drop of muriatic acid. Calcium silicate is grayer, very hard and does not fizz. Your pro can tell at a glance.

Why does my salt pool get more scale?

Salt cells tend to push pH up, and high pH makes calcium fall out of the water onto tile and the cell itself.

How do I keep scale from coming back?

Keep pH and alkalinity in range, watch calcium hardness, brush the tile line weekly and top off with fresh water. Many owners also book a cleaning every one to two years.

How do I measure linear feet?

Walk the edge of the pool at the water line and measure the full perimeter of the tile band, including steps and benches with tile. Add the spa and any tiled spillover.

Get your pool tile looking new again.

Get a free quote